Processed in your browser

Normalize Audio Volume

Adjust a local audio file to a chosen sample-peak target and export WAV or MP3. This is peak normalization, not LUFS mastering.

No account required
Selected files are processed in this browser, not sent to a Vaultxon media-processing server. Browser codec support and available memory vary by device.

What peak normalization does

Peak normalization measures the highest sample peak and applies a gain change so that peak approaches a target level. It can make a quiet file louder when there is headroom, or reduce the level of a file whose peak exceeds the target. It does not make every moment equally loud and does not automatically compress dynamic range.

This distinction matters for podcasts and music. A recording with one loud click and otherwise quiet speech may still sound quiet after peak normalization because the click determines the peak. Loudness normalization using LUFS and true-peak limits is a different process and is not what this tool claims to perform.

Choose a safe target

Leave headroom rather than aiming blindly at the maximum. A target closer to zero may increase the risk of clipping after later processing or encoding. A more conservative peak gives downstream tools space to operate. If you need a platform-specific integrated loudness target, use a meter and processor designed for that delivery specification.

Compare the normalized file at the same playback volume as the source. The louder file may seem better at first even if the difference is only gain. Listen for distortion on loud syllables, cymbals, transients and bass-heavy passages.

Recommended workflow

Select a supported file and allow the waveform or file analysis to finish. Choose the target peak, process the file, then audition a quiet section and the loudest section. If a single transient dominates the recording, consider editing or limiting that transient in an audio editor rather than pushing the entire recording harder.

Keep an untouched source. For interviews, voice notes and field recordings, normalization can make the signal easier to listen to, but it does not remove hum, hiss, echo or microphone noise.

Troubleshooting and limits

If the file becomes quieter, the measured source peak may already be above your target. If the result sounds distorted, lower the target and re-export. If perceived loudness changes little, dynamic range or isolated peaks may be controlling the gain. Large uncompressed files can use substantial browser memory.

MP3 output may require a browser-loaded encoder. If that resource cannot be retrieved, export WAV if available or retry after checking the connection. Verify the exported file before replacing the source.

Frequently asked questions

Does peak normalization make speech equally loud?

No. It changes gain based on sample peak; it does not level every phrase or apply compression.

Is this LUFS normalization?

No. The operation is peak normalization. Use a loudness meter and a LUFS-aware mastering workflow for broadcast or platform targets.

Can normalization repair clipping?

It cannot restore samples that were already clipped in the source. Lowering gain may reduce playback level but not reverse distortion.

Technical references

Measure the result against the intended use

Compare perceived loudness at matched playback volume and inspect the highest peaks. If the task requires integrated loudness, loudness range or true-peak compliance, use a tool that measures those values explicitly rather than treating peak normalization as mastering.